Mold thin board attached to mould after vaccumming between thin board and mould.

As let the heated material attach closely with mold being vacuumed. especially, Mesubiki method has the advantage of DOOR TRIM which is free from appearance and styling.

There are two types of method, MESUBIKI & OSUBIKI.

This molding is used for manufacturing of Laminate, at this time, mold pressure was given below 30㎏/㎤(2.94Mpa).

Both injection mold of thermoplastic resin and TRIMMING mold can be performed at a time, so this molding can make DOOR TRIM without other adhesive process.

On molding of material, BRACKET and RIB can be molded at a time.

After inserting fluid material into the mold with screw with a high pressure, cool down, it can mass-produce complex figures for a short time. the quality of products is under the control of material and pressure against injection. so technical skill will be required.

The adhesive method means to insert the end of hem into groove, as a method for decoration of DOOR TRIM.

not in need of special panel on working, can save cost.

Insert pvc powder into heated-mold, rotate and remove the powder parted from mold surface, that is, after cool down, generally used for a high-class motorcar in order to raise the quality of a product.